VW Golf R32 Forum banner
1 - 16 of 16 Posts

·
Been That long I can not reMember
Joined
·
1,162 Posts
Discussion Starter · #1 ·
Was thinking of putting a full Milltek system in but as its near enough 1.8k (which isn't cheap) would it be feasable/possible to do it in parts? I.e. Start at back and work way in?
 

·
Senior Member
Joined
·
565 Posts
Yea you can do it in sections mate. The manifolds are quite a big job to fit and cost a few a quid but the sound is unreal. I had a full Milltek on my old mk5 and I thought it was worth every penny.
 

·
Been That long I can not reMember
Joined
·
1,162 Posts
Discussion Starter · #3 ·
Yh that's what I thought spread the cost a bit better, best to leave manifolds till last then n start with back end?
 

·
Administrator
Joined
·
13,972 Posts
Have a look at a magnex / mongoose system or go to a custom exhaust shop

As miltek all sound the same and the above bang and pop more

Sent from my iPhone 9 in a Time Machine
 

·
Semi-Advanced Member
Joined
·
4,197 Posts
my system cost

350 for res cat back
100 for decat
480 manifolds

so you can get it a bit cheaper if you look hard enough
 

·
Been That long I can not reMember
Joined
·
1,162 Posts
Discussion Starter · #6 ·
That sounds decent is that milltek system ^^. ? I did like the looks off the scorpion system as a mate recommended it but they don't do manifolds as far as I can see unless they use them off another car if it'. A perfect fit or summit??
 

·
Registered
Joined
·
1,228 Posts
Have a look at a magnex / mongoose system or go to a custom exhaust shop

As miltek all sound the same and the above bang and pop more

Sent from my iPhone 9 in a Time Machine
X2
 

·
Eats Kitty Litter
Joined
·
7,307 Posts
MOLY90 Do you want a Mk4 or Mk5 system ?
 

·
Been That long I can not reMember
Joined
·
1,162 Posts
Discussion Starter · #10 ·
Mk4
 

·
Eats Kitty Litter
Joined
·
7,307 Posts
I sell MK4 de-cats and sport cats ,resonated and none resonated center pipes plus back box`s if you want a system half the price Milltek will screw you for.
 

·
Been That long I can not reMember
Joined
·
1,162 Posts
Discussion Starter · #12 ·
What about manifold and downpipes?
 

·
Eats Kitty Litter
Joined
·
7,307 Posts
Manifolds are never going to happen. To complex and custom parts needed plus i got to pay for a jig plus time to get the jig made if i want to keep the design to get more made later. If you want manifolds cheapest is Dubpower at £395
 

·
Semi-Advanced Member
Joined
·
4,197 Posts
Only thing id say about the price dubpower advertise is, I think it dont include VAT and delivery
 

·
Eats Kitty Litter
Joined
·
7,307 Posts
Price should be with VAT already added if you look on the site. Never dealt with them though.

"Price you pay (excluding P&P)"
 
1 - 16 of 16 Posts
Top