VW Golf R32 Forum banner
1 - 10 of 10 Posts

·
Registered
Joined
·
559 Posts
Discussion Starter · #1 ·
Planning on getting the milltek fitted tomorrow, quick question though, from other lads experience will I need to change the gasket where the cat meets the non res pipe?

Cheers for any advise.
 

·
Registered
Joined
·
559 Posts
themainlegend said:
Get VW gaskets, £16 for a pair. Like the others have said, use some paste on non res pipe to cats then clamp over it. Job done!
Have any of you guys just slid the non res end onto the cat end and clamped or has anyone used the original sleeve that came on the standard system? I didn't see a point as it was a solid fix?

Used holts as suggested.. Works a treat and sets fast
 

·
Cannot reMember
Joined
·
16,142 Posts
DANMKIV said:
Have any of you guys just slid the non res end onto the cat end and clamped or has anyone used the original sleeve that came on the standard system? I didn't see a point as it was a solid fix?

Used holts as suggested.. Works a treat and sets fast
I used a 63mm D clamp only
 

·
Registered
Joined
·
559 Posts
Discussion Starter · #10 ·
Cheempeej said:
I used a 63mm D clamp only
Cool, that's all I used but there seems to be a slight noise asif it's blowing but I know all joins we're tight and had paste on.
 
1 - 10 of 10 Posts
Top