VW Golf R32 Forum banner
1 - 4 of 4 Posts

·
Junior Member
Joined
·
8 Posts
hi,
im changeing my milltek exhaust back to the original.i have a full system,but will be wanting to replace from the manifold back,ie cats and res back section.
its been on the car for two years and is in good condition.i have stainless welded the cat section to the mid section as to do away the clamp,but if needed,this can be reinstated.
if anyone wants to do a swap,plus £400 for the standard one,let me know.it must be in good condition though.

thanks,
dan
 

·
Registered
Joined
·
1,039 Posts
dany said:
hi,
im changeing my milltek exhaust back to the original.i have a full system,but will be wanting to replace from the manifold back,ie cats and res back section.
its been on the car for two years and is in good condition.i have stainless welded the cat section to the mid section as to do away the clamp,but if needed,this can be reinstated.
if anyone wants to do a swap,plus £400 for the standard one,let me know.it must be in good condition though.

thanks,
dan
Where are you based? Is it a full milltek system manifold back? Is it non-res or resonated?
 

·
Cannot reMember
Joined
·
16,142 Posts
hi,
im changeing my milltek exhaust back to the original.i have a full system,but will be wanting to replace from the manifold back,ie cats and res back section.
its been on the car for two years and is in good condition.i have stainless welded the cat section to the mid section as to do away the clamp,but if needed,this can be reinstated.
if anyone wants to do a swap,plus £400 for the standard one,let me know.it must be in good condition though.

thanks,
dan
No problem
 
1 - 4 of 4 Posts
Top