Piece of S#!t Citroen

706 Views 8 Replies 6 Participants Last post by WillR32MKIV, May 23, 2013

wtabram

Discussion Starter · May 21, 2013

So, I'm in the middle (would have been finished by now) of fixing a friend's C2, the water pump went causing the belt to go loose and bent 3 valves.
Had the head fixed at a local cylinder head specialist, fitted a new gasket, water pump and cam belt.
Started it up after doing a oil change and coolant top up.
Now I have a problem where by its misfiring on cylinder 3.
I've checked the timing, spark and I'm pretty sure it's getting fuel. Can't work out for the life of me what's wrong.
Can anyone shed any light on a dark situation?

Wayne

Sent from my HTC Sensation Z710e using Tapatalk 2

Save

1 - 3 of 9 Posts

wtabram

Discussion Starter · #4 · May 21, 2013

Ordered a cheap cable from eBay, just waiting for it to arrive. So can't check fault codes till then.
Hmmm, blocked injector might not be too far from the truth, had a perished O ring on cylinder 3.
Any recommendations on how to clean/unblock ? I'll whip it out tomorrow and make sure it's not an obvious blockage.

Wayne

Sent from my HTC Sensation Z710e using Tapatalk 2

Save

wtabram

Discussion Starter · #7 · May 22, 2013

Has a all in one coil pack so can't even test by pulling a lead.
Gonna call a local diesel injector specialist and see if they can check/service the injector.

Wayne

Sent from my HTC Sensation Z710e using Tapatalk 2

Save

1 - 3 of 9 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month