VW Golf R32 Forum banner
1 - 3 of 3 Posts

· Registered
380 Posts
Discussion Starter · #1 ·
So trying to change my interior bulbs to LED's done all of them apart from rears. I've got this little led (see pic below) but how does it fit? The hole is far to big and it doesn't sit in existing holder. Any ideas?


Outerwear Sleeve Grey Collar Dress shirt


· Senior Member
188 Posts
You will see that the original bulb has the pos and neg wires wrapped round the plastic holder. If you remove the bulb and then bend wires out from new led to wrap around like original did.
That's how I did mine anyway. I found my new rear leds too dim and so swapped back to originals.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.