[Jamiew123]

Im going to have to solder a resister into my numberplate wire link to fit after market as ive tryed loads of bulb replacements and non work apparently puting a resister in will make them work how do i du this?

 

[Zig]

I wiered in a resistor to do the flapper solenoid delete, you just have to find the right wire, cut it, expose the ends and solder in your resistor, use a heat shrink to wrap it all up and then finish it off with insulating tape. Most important to get the correct resistor!!

 

[SI-R32]

For number plate lights or side lights just solder these in

http://pages.ebay.com/link/?nav=item.view&id=271051019648

Never had a problem well built to dissipate the heat always worked for over 2 years