VW Golf R32 Forum banner

Soldering resister

485 Views 2 Replies 3 Participants Last post by  SI-R32
Im going to have to solder a resister into my numberplate wire link to fit after market as ive tryed loads of bulb replacements and non work apparently puting a resister in will make them work how do i du this?
1 - 1 of 3 Posts
I wiered in a resistor to do the flapper solenoid delete, you just have to find the right wire, cut it, expose the ends and solder in your resistor, use a heat shrink to wrap it all up and then finish it off with insulating tape. Most important to get the correct resistor!!
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.