VW Golf R32 Forum banner
1 - 1 of 1 Posts

·
Senior Member
Joined
·
616 Posts
Discussion Starter · #1 ·
Well I've finished the run in procedures and I went to dump the oil today as well as tighten everything including the belt/supercharger, however, I couldn't find a tool that would fit the bolt that's holding the SC in position to keep the belt tight. I think it's a 19mm or 20mm bolt but everything I had was too wide to fit in the gap. Has anyone got a specific tool for this? I tried Halfords as that's all I've got round here but they were all wide like mine. Admittedly I didn't try very hard but that's just me! Any suggestions? :151:

Pic of where bolt is :idea:
 

Attachments

1 - 1 of 1 Posts
Top