Welcome message help

481 Views 4 Replies 2 Participants Last post by hall1979, Apr 17, 2013

hall1979

Discussion Starter · Apr 16, 2013

Hi,

Looking for a little help with enabling the "welcome message", I've been able to do the MTE and Lit Needles mod but when going to the address for the welcome message the original reading is not 02 but 00.

After some reading I found there may be a second location but that also reads 00 and not 02 so I'm not sure where the correct location is.

The 2 addresses I've tried are

044F
0417

Thanks

Save

1 - 2 of 5 Posts

jon_R32

· #3 · Apr 16, 2013

http://www.users.on.net/~graeme86/clusterprog/clusterprog.html

all here mate, mine only says welcome if I have the stereo switched off but I have factory nav with the full dash screen

Save

jon_R32

· #4 · Apr 16, 2013

hhhmmm says cant be done on half height dash but Im sure in my last 32 I had the welcome message and that was half height

Save

1 - 2 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month