Short run intake

Jasonworts · Oct 1, 2015

I know it's a long shot guys but I work as a engineer in a CNC shop and want to make my own short run intake, does anyone happen to have dimensions or better yet a engineers drawing of the intake manifold, I only need the position of the intake ports and bolt holes. Also it's a mk5 r32.

Also if I can get one made up is anyone else interested in one? Will be made of high grade stainless.

Thanks in advance

jameswalker · Oct 13, 2015

How good is your knowledge on intakes? There is a lot more to it than most people think!

matty.r32 · Oct 27, 2015

Why not just buy one off ebay they are reasonably cheap from Germany. If your intent on making your own you could buy one and use for measurements whilst you decide on how you will improve and execute the custom one, then you could sell it and recoup the initial outlay.

Lionborg · Oct 29, 2015

Why built it in stainless? It's much heavier than aluminum and stays hot much longer. Would prefer aluminum myself.

matty.r32 · Oct 29, 2015

Well spotted aluminium is much better material for inlet manifolds, i had not noticed the op said stainless.

Lucifer · Oct 29, 2015

Buy and copy this if you want.
http://www.r32oc.com/topic/182250-brand-new-hep-inlet-manifold/

matty.r32 · Oct 29, 2015

Lucifer said:
Buy and copy this if you want.
http://www.r32oc.com...inlet-manifold/

Or buy that and use it job done.

Short run intake

Our Vendors

Top Contributors this Month

Recommended Communities